GARAGE SALE!!!

[dc87gta]

Time to clean out the garage and free up some space...

1992 Chevy 350 from Z28, had ~120,000 miles when pulled, ran strong. Would need fresh gaskets and cleaned up. $300 OBO

1987 305 from my GTA, 98,000 miles, did not use/burn any oil. Very solid motor, very strong motor. Could be used as is if wanted without new gaskets. $150 OBO

TPI intake from same 1987 GTA. Upper/lower plenum, throttle body, runners, stock injectors, fuel rails, etc. No wiring harness or computer (still being used in car). $300 OBO

Stock 10-bolt rear end from GTA. 3.23 gears, posi, drum to drum. Only needs new brake lines and would be good to go. Drums/shoes/hardware have maybe 7000 miles on them. $125

Brand new GM Small block auto flexplate for one peice rear main seal engine. Came off ZZ383 crate motor that I purchased. Could not use due to car being a manual transmission. $30



Would like to sell locally, but if no interest will be going on ebay by end of week. Located in Medina right off of I-71 and route 18.

Thanks
Dan

[dc87gta]

ALso.....T56 retrofit crossmember, like new. used maybe 7000 miles. Went with different design with engine upgrade. For 94-97 T-56 into 82-92 f-body. Sell for $150 new. Black powdercoated. No damage. $100 OBO.


Thanks
Dan

[Car Enthusiast]

all i need is a block for a boat, would you do 200

[dc87gta]

$200 is a bit too low for the 350 engine considering I paid $350 for it when I bought it. Would like to get a little more then that for it.

Thanks

[91LT1Formula]

Still got L98?

[dc87gta]

Yes still have the L98.

[dc87gta]

bump....last call then I start placing ads in other places to sell this stuff....

[dc87gta]

Flexplate and posi rear end are pending sales...... everything else still available....

[Cashmunson]

motors still available? my buddies dad is looking for a 305 or 350 for his chevy truck

[TPI383]

Cash I have a 350 short block. need bearings. let go cheap just to get it outa here.
I have some rebuilt 305 heads also depends how much he wants ta bump the comp. up some.

[Mkos1980]

I'm looking for stock roller lifters, front thrust plate, hyd roller stock pushrods and the spider hold down with the lifter guides. Let me know if anybody has this stuff.

[Cashmunson]

Cash I have a 350 short block. need bearings. let go cheap just to get it outa here.
I have some rebuilt 305 heads also depends how much he wants ta bump the comp. up some.

he's looking for something decent on gas that'll run on 87. he traded a car for a truck and the truck has a blown motor with head damage. so he's looking for a basically complete ready to run long block that he can just drop in and go.

[dc87gta]

rear end and flex plate are sold...

motors, intake, and crossmember are still available...

[azrael91966669]

if i can ever find a job again ill buy that 350 off you lol

[firebirddave19]

do u have the 350 i give 300 cash

[dc87gta]

Yes I still have the 350. you have PM