Got my Magnaflow system

[89tpi]

Well here is the exhaust that's going to replace the broken Catcos and American thunder flowmaster syatem. What kinda gain should i see, if any? This is my 1st Magnaflow system which consists of 2 - 2 1/2" Magnaflow cats and the 15620 catback. I've only had Flows on my cars so I wanted a change.
I will post up the mods made to fit the system. The catback was $388 at Summit and the cats were $94 each and since I went to Summit I and bought them I get a $30 gift card. I also bought my Sportlines.
http://i90.photobucket.com/albums/k280/87tpi/100_2482.jpg
http://i90.photobucket.com/albums/k280/87tpi/100_2487.jpgRight here you can see that I won't need to lengthen the I pipe, it goes to the front of the cats.
http://i90.photobucket.com/albums/k280/87tpi/100_2485.jpg
http://i90.photobucket.com/albums/k280/87tpi/100_2480.jpg

[Ragtop89]

Hey, that's pretty fuggin sweet looking!

[Jeremy]

Looking good. Are you going to have a y-pipe made by an exhaust shop? It looks like that kit is meant for a single cat application, but it shouldn't be too hard to make it work. The Magnaflow should flow a bit more than the Flowmaster so you might notice a small difference in power and it will better complement later mods. I have heard those systems on 4thgens and they sound pretty nice. Good luck.

[89tpi]

The shop that's going to install it will actually have to trim some of the I pipe off and then just weld it up like normal. it looks the same as the american thunders I pipe.