t 56

[dream4ta]

i was just wanderin if anyone knows what all is needed to do a t56 swap in a 5 speed 3rd gen. i know the obvious stuff like a tranny, crossmember, bell housing, cluch and fliwheel, speedo stuff, and all the hydrolics but do i need a different drive shaft ar anything else.

[Jeremy]

You pretty much have it all covered. Stock length driveshaft is all that is needed with a factory rear end.

[dream4ta]

thanks man i just picked it up yesterday. do you know where i could get a good crossmember or am i just going to have to make my one

[malkavian]

dream check this page out . http://www.skulte.com/T56.html Just found it doing some research for my swap. Hope it helps.

[dream4ta]

thanks i cant wate to get my car back on the road but i dont think it is going to happin for awhile but all the info will help a lot