Would this sound good. (This is Matt)

[ErinRS91]

3.5" Over Axel Pipe with Spintechtm Cross Flow Muffler Using Dual 3" Tailpipes into 3" Stainless Round to Oval Tips. Single Catalyst for 82-92 Cars This system is $630.00


I called GMMG and spoke to Ron. He mentioned that they DONT make it for 3rdgens. He said you would have to work with the y pipe and add new hangers. He told me to get in contact with Hawks to see if they could sell me the GMMG exhaust for a thirdgen. I talked with Hawks and they sell the kit but its 800+ Shipping for direct bolt on. I asked for pics and maybe a sound clip and he said to me, to tell you the truth only a handful have purchased this system for their thirdgen and that they dont have pics or soundclips. "We mostly deal with LS1"

[ErinRS91]

http://www.mufflex-performance.com/car_craft.html

[chainsaw]

how much is the gmmg exhaust direct from gmmg?

[Mkos1980]

700

[TPI383]

If your gona spend that much just go with the mufflex 4inch with the spintech.

Personally No Exh. is worth $700 man. Thats what It will cost to do My complete turbo exh setup. and thats 304SS for everything.

[nightrider]

Since the car isn't a true daily driver so clearance isn't a huge concern and I expect you don't go offroad with the formie anyhow, and by the time you spend that much, you could go with a custom dual setup, possibly even in oval tubing.

Cars of the Past charges 515 to do a basic dual exhaust setup, so add an H pipe and depending on how much more oval tubing is, you would be more or less at the same amount to have them install it all for you.
Jeremy has done it himself from this site, so have a ton of people on TGO. I can't justify spending that much on an exhaust kit you would then have to modify either man.

[TPI383]

I agree when I had my Hooker SuperComp LTs and was gona stay N/A I called Dr.gas about a dual Ovel exh. setup with nice oval side exits with dual spintechs. dual cats.

it was like $700-800

[Mkos1980]

The more and more I think about it. I think I'll keep what I have. Its in good shape and still sounds good. Why dump money when you dont need too. I could use this money to buy prom burning software and use erins new labtop. All I have to do is reposition some stuff and get 3 seams welded and also work my y pipe

[TPI383]

E-mail me on prob butning software!!